The largest WestTechHA enclosure family is built for projects that need more internal room than Scout or Ranger, with standard Unloaded, Loaded, and Garage Panel options shown upfront.
Approximate overall outside dimensions are shown in inches first, with millimeters in parentheses, including the installed lid and mounting tabs.
The Command Product Family is for larger indoor automation projects where Scout and Ranger do not provide enough room. It keeps the same WestTechHA family structure while giving larger builds a cleaner enclosure path.
Choose Unloaded if you already have your hardware path. Choose Loaded if you want the selected electronics path pre-assembled, checked, and shipped with ESP32 Quick Start firmware.
Unloaded is the bring-your-own-hardware path. It includes the printed enclosure, lid, brass threaded inserts, standard enclosure hardware, and matched insert layout for the selected family. Electronics and firmware are not included unless specifically stated at checkout.
Loaded is the pre-assembled path for customers who want the selected electronics path handled before shipment. Loaded ESP32-based products include a basic pre-shipment diagnostic check and WestTech Home Automation ESP32 Quick Start firmware to help with first setup before you upload your own project firmware.
Command Garage Panel versions are designed for users who want to add a compatible garage wall remote inside the enclosure for convenience.
Loaded ESP32-based products are prepared before shipment so customers have a clear first setup path instead of receiving a blank board.
Before a Loaded product ships, WestTech Home Automation performs a basic diagnostic check on the installed ESP32 path. This helps confirm the device powers on, boots correctly, and is ready for the customer setup process.
Loaded ESP32-based products ship with WestTech Home Automation ESP32 Quick Start firmware installed. It is designed to make the device easier to find, connect, and verify on your network before you upload your own project firmware.
Customers should understand the filament, serviceable brass insert hardware, and use limitations before choosing an application.
WestTechHA enclosure families are printed in PLA+ 2.0 for indoor use.
These enclosures are not IP-rated and are not designed for wet or direct sunlight locations. Customers should confirm the intended environment is appropriate before ordering.
Current WestTech Home Automation enclosures include brass threaded inserts at key mounting points. These inserts make the enclosure easier to assemble, reopen, service, and reuse during future hardware changes without wearing out printed plastic screw holes.